Kestrel Adding Viper Camera

Configuring the Camera

*Please skip this step if using a 16 Channel NVR on the latest firmware. Ensure the cameras are set to DHCP.

1. Connect the cameras to a POE switch.
2. Run the IP Manager program on a PC connected to the same switch/network.
3. Select the camera you wish to edit.
4. Select the Batch Set NET option.
5. Assign each camera an IP address (Start and end) from the table below (This will link to a channel number on the NVR.

6. Assign a subnet of 255.255.255.0 and a gateway of 192.168.3.1
7. Enter the camera admin password.
8. Select Batch Set to save the changes to the camera.
9. Repeat for all.
10. Note which camera is which for when the cameras are being connected to the NVR.

Configuring the NVR

1. Right click and select Main Menu.
2. Under Channel, select Channel Set.
3. Select the Edit icon (Pencil).
4. Change the following settings.

5. Click OK to save.
6. Repeat for all other cameras.

Configuring the NVR via a Configuration File

1. Plug in the USB with the correct config file.
2. Right click and select Main Menu
3. Under Maintenance, select Config
4. Select the config file and select Import.
5. The unit will restart.